Datasheet Linear Technology LT6020IMS8#PBF — 数据表

制造商	Linear Technology
系列	LT6020
零件号	LT6020IMS8#PBF

双路微功耗，5V /Ој精密轨至轨输出放大器

数据表

预览并下载

PDF, 442 Kb, 语言: en, 文件上传: Jul 31, 2016, 页数: 20
Dual Micropower, 5V/μs Precision Rail-to-Rail Output Amplifier

从文件中提取

价格

打包

Package	MS-8
Package Code	MS8
Package Index	05-08-1660

参数化

Number of Channels	2
Unity Gain BW	0.4 MHz

Avol	56 dB
Common Mode Rejection Ratio	132 dB
Cdiff	2.5 pF
Design Tools	LTspice Model
Enoise 1/f Corner	1 Hz
Enoise Density	50 nV/rtHz
Export Control	no
Ibias	0.1 nA
Inoise	0.037 pA/rtHz
Ios	0.0001 µA
Iout	8 mA
Isupply	0.090 mA
LF Enoise	1.1 µVPP
Operating Temperature Range	-40 to 85 °C
Over-the-Top	no
PSRR	140 dB
Rail-to-Rail	Output
Rail-to-Rail In	no
Rail-to-Rail Out	yes
SR	5 V/µs
Shutdown	no
Single Supply	no
Ts (0.1%)	6000 ns
Type	VFB
VinCM High (from V+)	1.4 V
VinCM Low (from V-)	1.2 V
Voh (from V+)	0.1 V
Vol (from V-)	0.13 V
Vos	0.005 mV
Vos TC	0.2 µV/C
Vs Max	30 V
Vs Min	3 V

生态计划

RoHS

Compliant

其他选择

LT6020-1 LT6020-1

设计须知

下载
Precision Op Amp Enables Fast Multiplexing at Low Power &mdash DN536
PDF, 314 Kb, 档案已发布: Jan 23, 2015
从文件中提取
Precision Op Amp Enables Fast Multiplexing at Low Power
Design Note 536
Kris Lokere
Introduction
If you are designing a system that measures a number
of analog voltages, but not all at the same time, you
can reduce downstream circuitry by multiplexing the
measurements into a single output signal, then serially
process and digitize the original voltage levels using
shared components. The benefit is that the number
and size of signal chain components is a fraction of
that required by a per-channel design. Properly implementing a multiplexing solution requires attention to
a few details, especially if you want to quickly switch
between channels, measure accurately and maintain
low power consumption.
Respond Quickly
Multiplexing increases the frequency content of the
combined signal, since every time the multiplexer
switches channels, the multiplexed signal changes
value. Even if the input signals do not change quickly,
the multiplexed signal does, so any circuitry after the
multiplexer must respond quickly to these transitions.
For instance, if the output signal does not fully settle …
下载
Micropower Op Amp Drives 8-Channel 18-Bit Simultaneous Sampling ADC without Compromising Accuracy or Breaking the Power Budget &mdash DN541
PDF, 417 Kb, 档案已发布: Jun 23, 2015
从文件中提取
Micropower Op Amp Drives 8-Channel 18-Bit Simultaneous
Sampling ADC without Compromising Accuracy or Breaking
the Power Budget
Design Note 541
Guy Hoover
Introduction
The op amps used to drive 18-bit analog-to-digital
converters (ADCs) typically draw as much supply
current as the ADC itself, often with a maximum offset
spec that is well above that of the ADC. If multiple ADC
channels are required, the power dissipation from these
drivers quickly rises to unacceptable levels. consumption drops to 45mW (typical) by using the
deviceвЂ™s NAP mode.
The LT6020 is a dual micropower, 5V/Вµs precision
rail-to-rail output op amp with input offset voltage of
less than 30ВµV (maximum) that draws only 100ВµA per
amplifier (maximum).
The circuit of Figure 1 shows the LT6020 op amp
configured as a noninverting buffer driving the analog
inputs of the LTC2348-18. Maximum power dissipation
of each op amp is only 3mW. For all eight channels
this adds up to only 24mW, approximately half the
ADC power consumption at 10ksps. If 18-bit precision is required (SNR, THD, VOS), but …

模型线

系列: LT6020 (8)

LT6020HDD#PBF LT6020HDD#TRPBF LT6020HMS8#PBF LT6020HMS8#TRPBF LT6020IDD#PBF LT6020IDD#TRPBF LT6020IMS8#PBF LT6020IMS8#TRPBF

制造商分类

Signal Conditioning > Amplifiers > Operational Amplifiers (Op Amps) > Precision Amplifiers (Vos | Low Power Amplifiers (Is < 1mA/amp) | Low Bias Current Amplifiers (Ib < 100pA) | High Voltage Amplifiers (>12V) | Rail-to-Rail Amplifiers
Space & Harsh Environment > Extended Temperature Plastic (H & MP) > Extended Temperature (H & MP) Amplifiers

其他名称:

LT6020IMS8PBF, LT6020IMS8 PBF