Datasheet Texas Instruments LM3481MMX/NOPB — 数据表
| 制造商 | Texas Instruments |
| 系列 | LM3481 |
| 零件号 | LM3481MMX/NOPB |
用于Boost，SEPIC和反激式DC-DC转换器10-VSSOP -40至125的高效控制器
数据表
LM3481 / -Q1 High-Efficiency Controller for Boost, SEPIC and Flyback DC-DC Converters datasheet
PDF, 1.5 Mb, 修订版: F, 档案已发布: Nov 5, 2012
从文件中提取
价格
状态
| Lifecycle Status | Active (Recommended for new designs) |
| Manufacture's Sample Availability | No |
打包
| Pin | 10 |
| Package Type | DGS |
| Industry STD Term | VSSOP |
| JEDEC Code | S-PDSO-G |
| Package QTY | 3500 |
| Carrier | LARGE T&R |
| Device Marking | SJPB |
| Width (mm) | 3 |
| Length (mm) | 3 |
| Thickness (mm) | 1.02 |
| Pitch (mm) | .5 |
| Max Height (mm) | 1.07 |
| Mechanical Data | 下载 |
参数化
| Duty Cycle(Max) | 85 % |
| Iout(Max) | 10 A |
| Iq(Typ) | 3.7 mA |
| Operating Temperature Range | -40 to 125 C |
| Package Group | VSSOP |
| Rating | Catalog |
| Regulated Outputs | 1 |
| Special Features | Adjustable Current Limit,Enable,Frequency Synchronization,Light Load Efficiency,Pre-Bias Start-Up,UVLO Adjustable |
| Switch Current Limit(Typ) | 10 A |
| Switching Frequency(Max) | 1000 kHz |
| Switching Frequency(Min) | 100 kHz |
| Type | Controller |
| Vin(Max) | 48 V |
| Vin(Min) | 2.97 V |
| Vout(Max) | 500 V |
| Vout(Min) | 1.275 V |
生态计划
| RoHS | Compliant |
设计套件和评估模块
- Evaluation Modules & Boards: LM3481EVAL
High Efficiency Boost Switching Controller Eval Board with 12 Volt Output
Lifecycle Status: Active (Recommended for new designs) - Evaluation Modules & Boards: LM3481SEPICEVAL
LM3481 SEPIC Evaluation Board
Lifecycle Status: Active (Recommended for new designs) - Evaluation Modules & Boards: LM3481-FLYBACKEVM
Isolated Flyback Topology Evaluation Module for LM3481 Boost Controller
Lifecycle Status: Active (Recommended for new designs)
应用须知
- Softstart Using Constant Current Constant Voltage ApproachPDF, 337 Kb, 档案已发布: Jul 24, 2015
In many systems backup power is provided either by batteries or simply by a large value capacitor. Inthese applications the capacitor would only provide the current when the primary power source fails.Further, these applications are usually for light load currents. During normal operation the backupcapacitors are kept charged up by a DC/DC converter. The challenge involved in an application - Demystifying Type II and Type III Compensators Using Op-Amp and OTA for DC/DC CoPDF, 782 Kb, 档案已发布: Jul 11, 2014
- AN-1286 Compensation For The LM3478 Boost Controller (Rev. C)PDF, 356 Kb, 修订版: C, 档案已发布: Apr 23, 2013
The LM3478 is a low side N-Channel controller for switching regulators. Like many switching controllers,the added flexibility in component selection can cause problems for users when determining thecompensation scheme. It is the goal of this application report to present a decent groundwork to allow thereader to select with confidence the correct compensation components. To achieve this we l - AN-1484 Designing A SEPIC Converter (Rev. E)PDF, 220 Kb, 修订版: E, 档案已发布: Apr 23, 2013
In a single ended primary inductance converter (SEPIC) design, the output voltage can be higher or lowerthan the input voltage. The SEPIC converter shown in Figure 1 uses two inductors: L1 and L2. The twoinductors can be wound on the same core since the same voltages are applied to them throughout theswitching cycle. - Modeling & Design of Current Mode Control Boost Converters (Rev. B)PDF, 316 Kb, 修订版: B, 档案已发布: Apr 23, 2013
This application note presents a detail modeling and design of current mode control boost convertersoperating in the continuous conduction mode (CCM). Based on the derived small signal models, thedesign of a lag compensator for current mode control boost converters will be detailed. The LM3478 boostcontroller will be used in the example. Simulation and hardware measurement of frequency respo - AN-1990 Compensation for Current Mode Control SEPIC Converters (Rev. A)PDF, 247 Kb, 修订版: A, 档案已发布: Apr 23, 2013
This application note discusses the use of SEPIC converters in various applications. - LM34xx How to Design Flyback Converter with LM3481 Boost ControllerPDF, 1.7 Mb, 档案已发布: Sep 21, 2016
The TexasInstrumentsLM3481boostcontrolleris a versatilelow-sideN-FEThigh-performancecontrollerfor switchingregulators.Thedevicehaswiderangeof applicationssuchas automotivestart-stopapplication,one-cellor two-cellLi-ionbattery-poweredportableBluetoothaudiosystem,industrialsystemisolatedsupplies,and so forth,and supportstopologi
模型线
系列: LM3481 (2)
- LM3481MM/NOPB LM3481MMX/NOPB
制造商分类
- Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Controller (External Switch)