Datasheet Texas Instruments TPS61160DRVTG4 — 数据表

制造商	Texas Instruments
系列	TPS61160
零件号	TPS61160DRVTG4

数据表

价格

状态

打包

参数化

生态计划

设计套件和评估模块

• Evaluation Modules & Boards: TPS61160EVM-243
  TPS61160EVM-243 Evaluation Module
  Lifecycle Status: Active (Recommended for new designs)
  
  • 下载

应用须知

• 下载
  TPS6116x With Separate Power Stage and IC Input Voltages
  PDF, 194 Kb, 档案已发布: Apr 2, 2009
  This application report shows how to operate the TPS6116x integrated circuits (IC) with two separate input power rails, one for the boost power stage and one to power the IC itself. In this example, an input as low as 1.8 V from discharged dual-alkaline batteries supplies power to the boost stage, whereas a separate 3.3-V supply powers the IC.
• 下载
  How to Use Analog Dimming With TPS6116x
  PDF, 162 Kb, 档案已发布: Aug 5, 2011
  The TPS6116x family of devices are simple, white LED drivers that can drive up to 10 LEDs in series. The CTRL pin on these devices is the input for the integrated analog dimming circuitry but can only be used for PWM signals switching higher than 5 kHz. This application report shows a simple, external circuit that can be used to perform analog dimming from PWM signals that are below 5 kHz as well
• 下载
  Extending the Input Voltage Range of the TPS6116x/8x/9x WLED Drivers
  PDF, 124 Kb, 档案已发布: Aug 12, 2009
  The TPS6116x, TPS6118x and TPS6119x WLED driver and TPS6117x boost converter integrated circuits (IC) can operate with different input voltages, one powering the IC itself and the other powering the boost power stage. This application report explains various options on how to use the WLED drivers with split power rails. This allows these LED drivers to be used in applications where the available
• 下载
  Analog PWM Dimming in White-LED Drivers
  PDF, 539 Kb, 档案已发布: Dec 21, 2016
  Pulse-width modulation (PWM) is a common type of dimming used to adjust the current in white-LEDdriver devices. PWM dimming takes a rectangle waveform with variable positive duty cycle (D) and adjuststhe LED current proportionally. For many smaller format white LED drivers (7-inch screen size or smaller),the PWM signal is converted to a DC control voltage and made to drive the LED current in
• 下载
  Schottky Diode Selection in Asynchronous Boost Converters
  PDF, 491 Kb, 档案已发布: Sep 6, 2016
  Asynchronous boost converters require a Schottky diode as the rectifying element due to the diode's lowforward voltage and fast turn-on time. Because of these characteristics asynchronous boost converterscan have as good as, or better efficiency, than synchronous boost converters. This is especially true whenthe boost conversion ratios (VOUT/VIN) are high, and the Schottky diode conduction t
• 下载
  Inductor Selection in Boost Converters for LCD Backlight Applications
  PDF, 764 Kb, 档案已发布: Oct 24, 2016
  White LED drivers for LCD back-light applications are often designed for battery-powered devices. This makes circuit size and efficiency crucial. Because of this, selecting the optimal inductor is one of the mostimportant aspects of the design. This application note discusses the important parameters of the inductorand how to select the right inductor for the application.
• 下载
  Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. A)
  PDF, 1.1 Mb, 修订版: A, 档案已发布: May 11, 2015
• 下载
  Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
  PDF, 387 Kb, 修订版: B, 档案已发布: Jun 15, 2017
• 下载
  Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
  PDF, 418 Kb, 修订版: A, 档案已发布: Dec 11, 2018
  When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.

模型线

制造商分类

• Semiconductors > Power Management > LED Driver > Backlight LED Driver