Datasheet Texas Instruments LM2593HVSX-5.0/NOPB — 数据表

制造商	Texas Instruments
系列	LM2593HV
零件号	LM2593HVSX-5.0/NOPB

数据表

价格

状态

打包

参数化

生态计划

设计套件和评估模块

• Evaluation Modules & Boards: LM2593HVEVAL
  SIMPLE SWITCHERВ® Power Converter 150 KHz 2A Step-Down Voltage Regulator Evaluation Module
  Lifecycle Status: Active (Recommended for new designs)
  
  • 下载

应用须知

• 下载
  AN-643 EMI/RFI Board Design (Rev. B)
  PDF, 742 Kb, 修订版: B, 档案已发布: May 3, 2004
  Application Note 643 EMI/RFI Board Design
• 下载
  Input and Output Capacitor Selection
  PDF, 219 Kb, 档案已发布: Sep 19, 2005
• 下载
  AN-1197 Selecting Inductors for Buck Converters (Rev. B)
  PDF, 558 Kb, 修订版: B, 档案已发布: Apr 23, 2013
  This application report provides design information to help select an off-the-shelf inductor for anycontinuous-mode buck converter application.
• 下载
  AN-2155 Layout Tips for EMI Reduction in DC/ DC Converters (Rev. A)
  PDF, 3.6 Mb, 修订版: A, 档案已发布: Apr 23, 2013
  This application note will explore how the layout of your DC/DC power supply can significantly affect theamount of EMI that it produces. It will discuss several variations of a layout analyze the results andprovide answers to some common EMI questions such whether or not to use a shielded inductor.
• 下载
  AN-1566 Techniques for Thermal Analysis of Switching Power Supply Designs (Rev. A)
  PDF, 1.4 Mb, 修订版: A, 档案已发布: Apr 23, 2013
  This application note provides thermal power analysis techniques for analyzing the power IC.
• 下载
  AN-1889 How to Measure the Loop Transfer Function of Power Supplies (Rev. A)
  PDF, 2.7 Mb, 修订版: A, 档案已发布: Apr 23, 2013
  This application report shows how to measure the critical points of a bode plot with only an audiogenerator (or simple signal generator) and an oscilloscope. The method is explained in an easy to followstep-by-step manner so that a power supply designer can start performing these measurements in a shortamount of time.
• 下载
  Semiconductor and IC Package Thermal Metrics (Rev. C)
  PDF, 201 Kb, 修订版: C, 档案已发布: Apr 19, 2016
• 下载
  Low EMI Layout Made SIMPLE With LM43600/1/2/3 and LM46000/1/2 (Rev. A)
  PDF, 512 Kb, 修订版: A, 档案已发布: Sep 12, 2014
  Printed Circuit Board (PCB) layout for Switched Mode Power Supplies (SMPS) is critical to achieve proper converter operation good thermal performance and excellent radiated EMI performance. Optimized board layout for low radiated EMI is made very simple by the package and pin arrangement of the SIMPLE SWITCHER Synchronous Buck Converter family LM4360x and LM4600x
• 下载
  Simple Techniques Minimize Cross-Coupling in Distributed Power Systems
  PDF, 335 Kb, 档案已发布: Mar 21, 2007
• 下载
  AN-1253 Wide-Input, High Voltage Buck Converter (Rev. B)
  PDF, 184 Kb, 修订版: B, 档案已发布: Apr 23, 2013
  When the DC input voltage to a buck converter has a wide range, it becomes important to not only selecta suitable switching regulator IC for the application, but to select the power components to handle theworst-case input voltage. For a given component, the worst-case may be the maximum input voltage orthe minimum input voltage, but in fact may also be somewhere in between. A typical design
• 下载
  AN-1149 Layout Guidelines for Switching Power Supplies (Rev. C)
  PDF, 82 Kb, 修订版: C, 档案已发布: Apr 23, 2013
  When designing a high frequency switching regulated power supply layout is very important. Using agood layout can solve many problems associated with these types of supplies. The problems due to a badlayout are often seen at high current levels and are usually more obvious at large input to output voltagedifferentials. Some of the main problems are loss of regulation at high output current
• 下载
  AN-1081 Low-Cost Low-Parts-Count DC/DC Converter With Multiple Outputs (Rev. B)
  PDF, 124 Kb, 修订版: B, 档案已发布: Apr 23, 2013
  This application report describes a simple low cost, low parts-count multiple output DC/DC converterbased on the LM2596 five terminal step-down switching regulator. The circuit described provides multipleoutput voltages (positive and negative) with good regulation using a step-down converter circuit withflyback windings. It uses only one switching regulator IC.
• 下载
  AN-1229 SIMPLE SWITCHER PCB Layout Guidelines (Rev. C)
  PDF, 374 Kb, 修订版: C, 档案已发布: Apr 23, 2013
  This application report provides SIMPLE SWITCHER™ PCB layout guidelines.
• 下载
  AN-2162 Simple Success With Conducted EMI From DC-DC Converters (Rev. C)
  PDF, 2.5 Mb, 修订版: C, 档案已发布: Apr 24, 2013
  Electromagnetic Interference (EMI) is an unwanted effect between two electrical systems as a result ofeither electromagnetic radiation or electromagnetic conduction. EMI is the major adverse effect caused bythe application of switch-mode power supplies (SMPS). In switching power supplies EMI noise isunavoidable due to the switching actions of the semiconductor devices and resulting disconti
• 下载
  AN-1246 Stresses in Wide Input DC-DC Converters (Rev. C)
  PDF, 427 Kb, 修订版: C, 档案已发布: Apr 23, 2013
  This application note discusses stresses in wide input DC-DC converters.
• 下载
  AN-1520 A Guide to Board Layout for Best Thermal Resistance for Exposed Packages (Rev. B)
  PDF, 9.2 Mb, 修订版: B, 档案已发布: Apr 23, 2013
  This thermal application report provides guidelines for the optimal board layout to achieve the best thermalresistance for exposed packages. The thermal resistance between junction-to-ambient (ОёJA) is highlydependent on the PCB (Printed Circuit Board) design factors. This becomes more critical for packageshaving very low thermal resistance between junction-to-case such as exposed pad TSSOP

模型线

制造商分类

• Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Down (Buck) > Buck Converter (Integrated Switch)

其他名称:

LM2593HVSX5.0/NOPB, LM2593HVSX 5.0/NOPB