Datasheet Texas Instruments TPS62112RSARG4 — 数据表
制造商 | Texas Instruments |
系列 | TPS62112 |
零件号 | TPS62112RSARG4 |
采用QFN-16 16-QFN的5V,1.5A,17V Vin降压转换器-40至85
数据表
TPS6211x 17-V, 1.5-A, Synchronous Step-Down Converter datasheet
PDF, 1.2 Mb, 修订版: E, 档案已发布: Jun 18, 2015
从文件中提取
价格
状态
Lifecycle Status | Active (Recommended for new designs) |
Manufacture's Sample Availability | No |
打包
Pin | 16 | 16 |
Package Type | RSA | RSA |
Industry STD Term | VQFN | VQFN |
JEDEC Code | S-PQFP-N | S-PQFP-N |
Package QTY | 3000 | 3000 |
Carrier | LARGE T&R | LARGE T&R |
Device Marking | TPS | 62112 |
Width (mm) | 4 | 4 |
Length (mm) | 4 | 4 |
Thickness (mm) | .9 | .9 |
Pitch (mm) | .65 | .65 |
Max Height (mm) | 1 | 1 |
Mechanical Data | 下载 | 下载 |
参数化
Control Mode | Voltage Mode |
Duty Cycle(Max) | 100 % |
Iout(Max) | 1.5 A |
Iq(Typ) | 0.02 mA |
Operating Temperature Range | -40 to 85 C |
Package Group | QFN |
Rating | Catalog |
Regulated Outputs | 1 |
Special Features | Enable,Frequency Synchronization,Light Load Efficiency,Power Good,Synchronous Rectification |
Switching Frequency(Max) | 1100 kHz |
Switching Frequency(Min) | 900 kHz |
Type | Converter |
Vin(Max) | 17 V |
Vin(Min) | 3.1 V |
Vout(Max) | 5 V |
Vout(Min) | 5 V |
生态计划
RoHS | Compliant |
设计套件和评估模块
- Evaluation Modules & Boards: TPS62110EVM-101
TPS62110 Evaluation Module
Lifecycle Status: Active (Recommended for new designs)
应用须知
- Adding Hysteresis to Low-Battery Input on the TPS6211xPDF, 88 Kb, 档案已发布: Nov 2, 2009
The low-battery input (LBI), available on several step-down converters, is often used to shut down the converter when the input voltage falls below a set threshold. This prevents damage to the battery and signals that the battery is at the end of its life and must be charged or replaced. Batteries have internal resistance that causes the voltage to drop as the load increases. This internal resista - TPS6211X Driving EN and SYNC pinPDF, 70 Kb, 档案已发布: Jan 15, 2008
The TPS6211x high-input-voltage buck converters operate over a wide, input-voltage range. The control and input signal can also be controlled from 1.8-V logic levels up to maximum input voltage.One characteristic of the EN and SYNC control circuits is the increase in leakage current when these pins are driven by a voltage level less than 4 V.In this application report, the difference in th - Optimizing Resistor Dividers at a Comparator (Rev. A)PDF, 120 Kb, 修订版: A, 档案已发布: Jun 3, 2013
- Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. A)PDF, 1.1 Mb, 修订版: A, 档案已发布: May 11, 2015
- Five steps to a great PCB layout for a step-down converterPDF, 162 Kb, 档案已发布: Jan 29, 2015
- Understanding the Absolute Maximum Ratings of the SW Node (Rev. A)PDF, 755 Kb, 修订版: A, 档案已发布: Jan 13, 2012
- Testing tips for applying external power to supply outputs without an input voltPDF, 110 Kb, 档案已发布: Oct 24, 2016
- Basic Calculation of a Buck Converter's Power Stage (Rev. B)PDF, 202 Kb, 修订版: B, 档案已发布: Aug 17, 2015
- Extending the Soft Start Time Without a Soft Start Pin (Rev. B)PDF, 387 Kb, 修订版: B, 档案已发布: Jun 15, 2017
- Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain OutputsPDF, 130 Kb, 档案已发布: Sep 19, 2011
- QFN and SON PCB Attachment (Rev. B)PDF, 821 Kb, 修订版: B, 档案已发布: Aug 24, 2018
- IQ: What it is what it isn’t and how to use itPDF, 198 Kb, 档案已发布: Jun 17, 2011
- Performing Accurate PFM Mode Efficiency Measurements (Rev. A)PDF, 418 Kb, 修订版: A, 档案已发布: Dec 11, 2018
When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.
模型线
系列: TPS62112 (4)
- TPS62112RSAR TPS62112RSARG4 TPS62112RSAT TPS62112RSATG4
制造商分类
- Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Down (Buck) > Buck Converter (Integrated Switch)