Datasheet Texas Instruments BQ27010 — 数据表

数据表

价格

状态

打包

生态计划

应用须知

• 下载
  Configuring the bq27010/210 for Gas Gauge Applications
  PDF, 252 Kb, 档案已发布: Feb 23, 2007
  Accurate performance of the bq27x10 gas gauge requires that the 10 user-configurable EEPROM coefficients be programmed to values that reflect the appropriate host system and battery characteristics. This application report provides the basis for determining the optimal EEPROM coefficients from the host system operational characteristics and battery characterization data. Appendix A specifically ad
• 下载
  Transition From Prior bqJunior Gauges to the bq27x10
  PDF, 64 Kb, 档案已发布: Jul 17, 2007
• 下载
  Using the bq27x00 With a Primary Cell Battery
  PDF, 42 Kb, 档案已发布: Dec 15, 2005
  The bq27x00 is an accurate coulomb counter and contains algorithms to dynamically compensate the available capacity for temperature and discharge rate. If direct drive from the gauge to an LED display is not required, the bq27x00 can be used as an accurate gas gauge solution for a primary cell battery. Although the bq27x00 was designed for a single-cell rechargeable lithium-ion or lithium-polymer
• 下载
  Multicell Li-Ion and Li-Pol Battery Gas-Gauge Application Using the bqJunior
  PDF, 58 Kb, 档案已发布: May 26, 2006
  The bqJuniorв„ў series of gas gauges are designed to operate from a single-cell, lithium-ion or lithium-polymer battery. Many applications that could benefit from using these gas gauges use two or more lithium cells in series, where the battery voltage exceeds the operating voltage for the bqJuniorв„ў gas gauges. This application report describes a low-component count solution for using th
• 下载
  Building a Superior Battery Monitor with the bq27x00
  PDF, 43 Kb, 档案已发布: Jun 20, 2005
  The bq27x00 is a complete gas gauge solution for lithium-ion and lithium-polymer batteries. The bq27x00 also has internal registers and control commands that enable the host to use it as a battery monitor. A battery gas gauge solution can be built one of two ways: ignore all algorithms built into the bq27x00 and use the primitive functions to build a fully customized solution, or use some of the h
• 下载
  Battery Authentication and Security Schemes (Rev. A)
  PDF, 52 Kb, 修订版: A, 档案已发布: Jul 17, 2014
• 下载
  HDQ Communication Basics (Rev. A)
  PDF, 103 Kb, 修订版: A, 档案已发布: Sep 18, 2008
  This report compares the communication timing specifications for the different battery gas gauge and battery monitor products. It discusses some of the interface requirements necessary for robust HDQ communication, such as the need for a break prior to each communication, how to reliably read 16-bit dynamic values over the 8-bit bus, and the need for some noise filtering on the HDQ line. It also
• 下载
  ESD and RF Mitigation in Handheld Battery Pack Electronics
  PDF, 68 Kb, 档案已发布: Mar 6, 2008
  It is imperative to protect the electronics in a consumer-removable battery pack from ESD damage. Even an upset without permanent damage may be unacceptable to the end-user. Handheld equipment that contains a transmitter also may require protection to guard against improper measurement and/or upset due to the affect of the radio frequency (RF) on the circuitry. Because the RF field strength varies
• 下载
  Feature Set Comparison of bq27x00, bq27x10, bq27500, and bq27510 (Rev. A)
  PDF, 65 Kb, 修订版: A, 档案已发布: Dec 2, 2008
  Feature Set Comparison of bq27x00, bq27x10, bq27500 and bq27510
• 下载
  Single Cell Impedance Track Printed-Circuit Board Layout
  PDF, 403 Kb, 档案已发布: Feb 22, 2008
  bq20z70/90 Printed-Circuit Board Layout Guide
• 下载
  Single Cell Gas Gauge Circuit Design
  PDF, 154 Kb, 档案已发布: Feb 22, 2008
• 下载
  MSP430 Microcontroller SW for Handheld Fuel Gauges and Battery Authentication (Rev. A)
  PDF, 350 Kb, 修订版: A, 档案已发布: May 26, 2010
  MSP430, bq26100, bq26100EVM, bq26150, bq26150EVM, bq26500, bq27000, bq27000EVM, bq27200, b MSP430 Microcontroller Software for Handheld Fuel Gauge & Battery Authentication

模型线

制造商分类

• Semiconductors> Power Management> Battery Management Products> Battery Fuel Gauge