Datasheet Texas Instruments TPS65105PWPG4 — 数据表

制造商Texas Instruments
系列TPS65105
零件号TPS65105PWPG4
Datasheet Texas Instruments TPS65105PWPG4

带全功能的4通道LCD偏置位置电荷泵,3.3V LDO控制,最小0.96A将Ilim,故障和VCOM 24-HTSSOP -40提升至85

数据表

TPS6510x Triple Output LCD Supply With Linear Regulator and VCOM Buffer datasheet
PDF, 1.7 Mb, 修订版: D, 档案已发布: Aug 31, 2016
从文件中提取

价格

状态

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

打包

Pin24
Package TypePWP
Industry STD TermHTSSOP
JEDEC CodeR-PDSO-G
Package QTY60
CarrierTUBE
Device MarkingTPS65105
Width (mm)4.4
Length (mm)7.8
Thickness (mm)1
Pitch (mm).65
Max Height (mm)1.2
Mechanical Data下载

参数化

DisplayTypeLCD Unipolar
IC IntegrationLCD Bias
Level Shifter/Scan DriverN/A Ch
Pin/Package24HTSSOP, 24VQFN
Source Driver Voltage(Max)15 V
Source Driver Voltage(Min)5 V
Special FunctionVCOM/OpAmp
Target Application7 inches or less,7 to 13 inches
Vin(Max)5.8 V
Vin(Min)2.7 V

生态计划

RoHSCompliant

设计套件和评估模块

  • Evaluation Modules & Boards: TPS65140EVM-031
    TPS65140 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)
  • Evaluation Modules & Boards: TPS65100EVM-030
    TPS65100 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)

应用须知

  • Load Disconnect for the TPS6510x (Rev. A)
    PDF, 69 Kb, 修订版: A, 档案已发布: Feb 8, 2017
    Many boost converters have an external rectifier diode. The input voltage of the TPS6510x main boostconverter is connected to the output voltage when the device is disabled. Due to the direct pass from theinput to the output, the converter has no short-circuit protection. This application report describes how touse a PNP transistor and some passive components to disconnect the boost converte
  • Customizing your TPS6510x/TPS6514X
    PDF, 233 Kb, 档案已发布: Jun 22, 2004
    This application report shows how to use external circuitry to boost the output voltage capability of the positive and negative charge pumps of the TPS6510x and TPS6514x triple output power supplies. In addition the report shows how to use external circuitry to modify the internally controlled sequencing implement sequencing delay and short circuit protection.
  • How to Compensate the TPS6510x and the TPS6514x
    PDF, 1.1 Mb, 档案已发布: Aug 30, 2016
    The boost converters in the TPS6510x (TPS65100 TPS65101 TPS65105) and the TPS6514x (TPS65140 TPS65141 TPS65145) series use external loop compensation providing high flexibility in LCD supply design. If designing a typical application scheme use the recommended components from the TPS6510x datasheet (SLVS496) and the TPS6514x datasheet (SLVS497). This application note gives a deeper understand
  • Basic Calculation of an Inverting Buck-Boost Power Stage (Rev. A)
    PDF, 431 Kb, 修订版: A, 档案已发布: Aug 28, 2017
    This application note provides basic formulas that you need to design the power stage of an invertingbuck-boost converter. The premise is that the power switch is integrated in the IC and the rectification isdone by a diode (non-synchronous power stage). It provides all the formulas and considerations that youneed to select the external power components such as the inductor the diode and t
  • Generation of a VCOM buffer input using PWM signal
    PDF, 439 Kb, 档案已发布: Dec 21, 2015
    In an LCD the backlight shines through the liquid crystal material and the voltage across the liquid crystal controls how much light shines through it. An active matrix LCD (AMLCD) contains many pixels arranged in a grid pattern. The voltage across each pixel is controlled individually so that high resolution images can be created. One terminal of every pixel is connected to a common plane. The v
  • Understanding Undervoltage Lockout in Power Devices (Rev. A)
    PDF, 90 Kb, 修订版: A, 档案已发布: Sep 19, 2018
    Many integrated circuits include an undervoltage lockout (UVLO) function to disable the device at low supply voltages. Below the minimum supply voltage the function and performance of a device may be undefined making it impossible to predict system behavior. This application note explains how to correctly understand the undervoltage lockout specification in the data sheets of TI's power products.
  • Minimizing Ringing at the Switch Node of a Boost Converter
    PDF, 201 Kb, 档案已发布: Sep 15, 2006
    The application report explains how to use proper board layout and/or a snubber to reduce high-frequency ringing at the switch node of a boost converter.
  • Basic Calculation of a Boost Converter's Power Stage (Rev. C)
    PDF, 186 Kb, 修订版: C, 档案已发布: Jan 8, 2014
    This application note gives the equations to calculate the power stage of a boost converter built with an IC with integrated switch and operating in continuous conduction mode. It is not intended to give details on the functionality of a boost converter (see Reference 1) or how to compensate a converter. See the references at the end of this document if more detail is needed.

模型线

系列: TPS65105 (5)

制造商分类

  • Semiconductors > Power Management > LCD/OLED Display Bias Solutions