Datasheet Texas Instruments CC1312R1F3RGZT — 数据表
| 制造商 | Texas Instruments |
| 系列 | CC1312R |
| 零件号 | CC1312R1F3RGZT |
SimpeLink低于1 GHz CC1312R无线MCU 48-VQFN -40至85
数据表
CC1312R SimpleLink High-Performance Sub-1 GHz Wireless MCU datasheet
PDF, 547 Kb, 档案已发布: Jan 16, 2018
从文件中提取
价格
状态
| Lifecycle Status | Preview (Device has been announced but is not in production. Samples may or may not be available) |
| Manufacture's Sample Availability | No |
打包
| Pin | 48 |
| Package Type | RGZ |
| Industry STD Term | VQFN |
| JEDEC Code | S-PQFP-N |
| Package QTY | 250 |
| Carrier | SMALL T&R |
| Width (mm) | 7 |
| Length (mm) | 7 |
| Thickness (mm) | 0.9 |
| Pitch (mm) | 0.5 |
| Max Height (mm) | 1 |
| Mechanical Data | 下载 |
参数化
| Data Rate(Max) | 4000 kbps |
| Device Type | SimpleLink Wireless MCU |
| Flash | 352 KB |
| Frequency Bands | Sub-1 GHz MHz |
| GPIO | 30 |
| RX Current (Lowest) | 5.7 mA |
| Rating | Catalog |
| Security Enabler | Cryptographic acceleration,Debug security,Device identity,Software IP protection |
| Sensitivity (Best) | -125 dBm |
| TX Power(Max) | 14 dBm |
| Technology | Sub-1 GHz |
| Throughput(Max) | 4.0 Mbps |
生态计划
| RoHS | See ti.com |
设计套件和评估模块
- Development Kits: LAUNCHXL-CC1312R1
SimpleLink Sub-1 GHz CC1312R Wireless Microcontroller (MCU) LaunchPad Development Kit
Lifecycle Status: Active (Recommended for new designs) - Debug Probes/Analyzers: TMDSEMU200-U
XDS200 USB Debug Probe
Lifecycle Status: Active (Recommended for new designs)
应用须知
- Low-Power ADC Solution for CC13x2 and CC26x2PDF, 190 Kb, 档案已发布: Mar 2, 2018
The 12-bit analog-to-digital converter (ADC) peripheral block included in CC13x2 and CC26x2 deviceswhich is typically used by the Sensor Controller requires the SCLK_HF signal and is therefore notavailable in low-power (2 MHz) mode. The goal of this application note is to help users create an 8-bitsuccessive-approximation (SAR)-type low-power ADC using the CC13x2 and CC26x2 Sensor Con - Single-Chip Flow Metering Solution With the CC13x2R Wireless MCUsPDF, 88 Kb, 档案已发布: Feb 27, 2018
- Sensor Sequencing Using the CC13x2 and CC26x2 Sensor ControllerPDF, 252 Kb, 档案已发布: Mar 5, 2017
The purpose of this application note is to demonstrate how current consumption can be minimized bymaking the Sensor Controller automatically enable a sensor at a designated time period before the sensoris to be sampled. This implementation allows the Sensor Controller to stay in the lowest-possible powermode while the sensor boots and then start up when the sensor is ready. In this appl - Hardware Migration From CC1310 to CC1312RPDF, 27 Kb, 档案已发布: Oct 17, 2017
This application report describes the required hardware changes when moving from the CC1310 to the CC1312R SimpleLin™ wireless MCU. - Ultra-Low Power Designs With the CC13x2 and CC26x2 Sensor ControllerPDF, 87 Kb, 档案已发布: Feb 27, 2018
- Getting Started With the CC13xx and CC26xx Sensor ControllerPDF, 1.1 Mb, 档案已发布: Oct 6, 2017
This application note is intended as an introduction to the low-power Sensor Controller Engine found in theCC13xx and CC26xx devices. It explains the benefits of using the Sensor Controller in various use cases.The application note also describes how to get started using the Sensor Controller and directs you to therequired tools and collaterals.
模型线
系列: CC1312R (3)
- CC1312R1F3RGZR CC1312R1F3RGZT XCC1312R1F3RGZR
制造商分类
- Semiconductors > Wireless Connectivity > SimpleLink Solutions > Sub-1 GHz