MCP1501 1.0 ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings(†) VDD.5.5V Maximum current into VDD pin . 30 mA Clamp current, IK (VPIN < 0 or VPIN > VDD). ±20 mA Maximum output current sunk by OUTPUT pin .30 mA Maximum output current sourced by OUTPUT pin .30 mA (HBM:CDM:MM). (2 kV:±1.5 kV:200V) † Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operation listings of this specification is not implied. Exposure above maximum rating conditions for extended periods may affect device reliability. TABLE 1-1: DC CHARACTERISTICS Electrical Characteristics: Unless otherwise specified, VDD(MIN) VDD 5.5V at –40C TA +125C. Characteristic Supply Voltage Power-on-Reset Release Voltage Power-on-Reset Rearm Voltage Output Voltage MCP1501-10 MCP1501-12 MCP1501-18 MCP1501-20 MCP1501-25 MCP1501-30 MCP1501-33 MCP1501-40 Temperature MCP1501-XX Coefficient Line Regulation Load Regulation Dropout Voltage Power Supply Rejection Ratio 2015-2017 Microchip Technology Inc. Sym. Min. Typ. Max. Units VDD VDD VDD VDD VDD VDD VDD VDD VPOR 1.65 1.65 2.0 2.25 2.70 3.2 3.5 4.3 — — — — — — — — — 1.45 5.5 5.5 5.5 5.5 5.5 5.5 5.5 5.5 — V V V V V V V V V — — 0.8 — V VOUT 1.0230 1.2488 1.7982 2.0460 2.4975 2.9970 3.2967 4.0919 — 1.0240 1.2500 1.800 2.0480 2.500 3.000 3.300 4.0960 10 1.0250 1.2513 1.8018 2.0500 2.5025 3.0030 3.3033 4.1001 50 V V V V V V V V ppm/C VOUT / VIN VOUT / IOUT — 5 50 ppm/V VDO — TC PSRR — 10 ppm – 40 ppm – sink sink 15 ppm – 70 ppm – source source — 200 94 dB Conditions MCP1501-10 MCP1501-12 MCP1501-18 MCP1501-20 MCP1501-25 MCP1501-30 MCP1501-33 MCP1501-40 ppm/mA –5 mA < ILOAD < +5 mA mV –5 mA < ILOAD < +2 mA 1.024V option, VIN = 5.5V, 60 Hz at 100 mVP-P DS20005474E-page 3